Dometic RM2451 Uživatelský manuál

INSTALLATION ANDOPERATING INSTRUCTIONSREFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATIONRM 2451USA Corporate Office CANADAService Office 2320 Industrial P

10DESCRIPTION OF OPERATING MODESAUTO MODEWhen operating in the AUTO mode, the AUTO modeindicator lamp (A) will illuminate.The control system will auto

11! WARNINGCLEANING THE REFRIGERATORCleaning the refrigerator is usually done after it is de-frosted or put into storage. To clean the interior liner

12MAINTENANCE & SERVICEThe user should be aware of service that must bedone on a regular schedule to keep the refrigeratoroperating properly. The

13C. Check the control system by connecting/disconnect-ing 120 volt AC power, start/stop the engine, etc.Compare the operation with the operation desc

14F. Burner dirty.Clean. (See section Maintenance & Service, item 3.Periodic Maintenance, Paragraph E item 1-14).G. LP gas pressure low at burner.

15CERTIFIED VENT SYSTEM KITSREFRIGERATOR KITMODEL NO. COMPONENTS PART NO.RM 2451 3A Roof Base 3103633.XXX*Roof Cover 3103634.XXX*Lower Side Vent 31093

16MO-FO 0413RM 2451

3Refrigerator control panelCHECKGASAUTOONOFFAUTOMATIC REFRIGERATOR TEMPERATURE CONTROL12ABLEGEND1. Main Power Button ON/OFF2. AUTO/GAS Mode Selector B

4INSTALLATIONGENERAL INSTRUCTIONThis appliance is designed for storage of foods andstorage of frozen foods and making ice.This appliance is certified

5VENTILATION HEIGHTSRefer to FIG. 3 page 4.CLEARANCESMinimum clearances in inches to combustible materialsare:G: Top 0K: Side 0L: Bottom 0M: Rear 0N:

6INSTALLING REFRIGERATOR INENCLOSURENOTE: DO NOT install the appliance directly oncarpeting. Carpeting must be removed orprotected by a metal or wood

7Replace the top decoration panel. Be careful not to pinchthe wires behind the panel.Make sure the tabs snap back into the holes in the hingeplate.STE

8ELECTRICAL CONNECTION120 Volts AC ConnectionThe refrigerator is equipped with a three-prong (ground-ing) plug for your protection against shock hazar

9GAS MODE1. Move the AUTO/GAS mode selector button (2) to theUP position. The AUTO mode indicator lamp (A) willgo off. Within 45 seconds the burner sh