Dometic EA3140 Uživatelský manuál stáhnout pdf (Strana 7)

USING THE REFRIGERATOR

The refrigerator provides sufficient storage

space for food, milk, drinks etc The shelves on

the inside of the door (EA 3140) are suitable for

bottles, tins and small packets. Two can be used

together to form a full-depth shelf or they can be

used separately, leaving space at the front for

bottles and other larger items.

All food should be stored in its original packaging

or in closed containers. Liquids should also only

be stored in closed bottles or containers. In this

way food remains moist, odours do not form and

neither does excess ice form on the cooling unit.

Allow hot food and drink to cool down before

placing them in the refrigerator.

Do not keep any easily combustible

substances such as ether, petrol, adhesive,

propane gas etc. in the refrigerator, it could

explode.

ICE CUBES

Fill the ice tray to 4/5 with drinking water, and

place the ice tray on the ice-tray shelf. Wipe off

any excess water to prevent the ice tray from

freezing to the surface.

To speed up the making of ice cubes, turn the

thermostat to position 5 for a short while.

Remember to turn the dial to its normal setting

when the ice cubes are frozen.

To remove the cubes from the ice tray, hold it

under running water. The ice cubes can now be

taken out easily.

CARE AND MAINTENANCE

Fully automatic defrosting

The appliance is fitted with a fully automatic

defrosting system. Defrosting of the frost starts

automatically for 2 hours long in every 24 hours.

The defrost water is automatically evaporated by

the heat generated by the appliance. After

defrosting is completed, cooling will

automatically be started again.

Defrost water

During the defrosting process the water runs

through a hose into a container on the back of

the refrigerator where it evaporates. This

container does not need to be emptied.

Cleaning

Clean the inside of your refrigerator regularly to

keep it fresh and hygienic. Switch off the

appliance and pull out the plug. Clean the

interior and fittings carefully with a mild detergent

in lukewarm water.

Never use acidic, abrasive or strong-smelling

detergents or wax polishes as these will damage

the surfaces and leave an unpleasant smell.

The outside should occasionally be dusted or

wiped over with a damp cloth. The door seal

should only be cleaned with water and rubbed

down with talcum powder from time to time.

If possible, the unit should also be dusted

occasionally with a brush or, even better, with a

vacuum cleaner. Ensure that the plug is

disconnected.

Longer periods of absence...

If you wish to switch off the appliance for a longer

period of time, pull out the plug, defrost the

refrigerator and clean it carefully. Leave the door

open to prevent unpleasant odours from forming.

Changing the lightbulb

If the lightbulb needs changing, pull out the plug

and proceed as follows:

Press the metal reflector to one side and draw

the lamp covering backwards. Replace the bulb

and push the covering back into place.

A new 10-watt bulb can be obtained at any

service shop.

Reversing the door hang, Fig. 6

Lay the appliance on its back. Remove the 8

screws (1). Remove the door, together with the

two hinges (2), from the housing.

Remove the two cover caps (3) from the housing

and place them in the open hinge holes in the

housing. Place the bottom righthand hinge in the

top left of the door and the top righthand hinge in

the bottom left of the door and hang the door on

its hinges in the open cover cap holes in the

housing. Secure the hinges and cover caps with

the 8 screws.

Check that the door closes easily and is sealed

properly.

Reversing the door hang at a fridge with

lock

Proceed according to afore-mentioned with the

following supplement:

Remove the hinge plate, then reversing place it

into the open hinge-hole of the bottom

righthand hinge.

Replacing the decorative door panel, Fig. 7-9

Remove the two screws (1) from the upper hinge

of the door.

Pull the door together with the hinge away from

the housing and up off the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door

frame and insert the new panel (7), so that the

upper edge of the panel runs exactly parallel to

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Dometic EA3140 Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro ne Dometic EA3140