Dometic DS200FS Uživatelský manuál stáhnout pdf (Strana 6)

units. Foot frames with grilles ensure sufficient

ventilation.

These models can be also build in into the

furnitures with sliding hinges or simply be pushed

into a given space. In this case please take into the

consideration items listed below.

IMPORTANT

Please follow the installation details below

carefully. Guarantee is valid for products

installed as described only.

1. The refrigerator must be le

vel both directions

2. There should be 20 mm clearance to the wall

3. Ventilation must be provided as shown in

alternatives A, B, C or D (fig 4-5)

Figure 4.

Figure 5.

4. Only the entire cooling unit must project into

the duct as shown

5. Air passing thr

ough the duct must not be

preheated by any source of heat

4. Positioning the appliance

When first using this refrigerator please consider the

following points:

ENSURE REFRIGERATOR IS LEVEL

THE PIPEWORK AT THE BACK GETS HOT IN USE

THE REFRIGERATOR HAS NO 'MOTOR' AND IS

THEREFORE VIRTUALLY SILENT

ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING

During the refrigeration process, the appliance

gives off heat from the condenser (under the

upper part of the rear cover) into the surrounding air.

The more ventilated the condenser is, the more

effective the refrigeration will be.

The other condition for satisfactory operation is that

the appliance is levelled. This could be checked by

placing a glass of water on top of the appliance.

It is important that the appliance is not directly

exposed to radiated heat (sunlight, radiator, near an

oven, etc.).

Please do not place the refrigerator onto thick carpet!

4.1. Installation instructions

All four sizes of the miniCool family are available in

built-in and freestanding version.

4.1.1. Built-in versions

This version is intended for built in purposes. Built in

models do not have foot frames, cooling unit covers,

door panels compared to the freestanding versions

(figure 1).

The miniCool can be screwed to the furniture using the

fittings at the bottom. Drive in the screws (figure 3).

Difference between pivot points can be equalized with

the help of the sliding hinge, which is a standard

accessory for this version. The hinge recommended

to fix onto the top third of the refrigerator's door.

Please make sure before final fixing that the flat sliding

part allows normal door opening in order to avoid door

sticking (figure 3).

Figure 3.

4.1.2. Freestanding versions

These versions are intended for freestanding use.

Cooling unit covers protect the hot parts of the cooling

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Dometic DS200FS Uživatelský manuál Strana 6

Komentáře k této Příručce

Související produkty a manuály pro ne Dometic DS200FS