Dometic CA2500 Uživatelský manuál Strana 23

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 120
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 22
23
Dometic CA2500 Installation
Make an opening on one side in order to feed through the electrical
power supply cable.
7.2.2 Installation in an existing sunroof opening
I
Note
Existing roof hatch openings of 400 to 435 mm are suitable for the instal-
lation of the roof air conditioner. If the opening for the installation of the
device is larger than 435 mm, it is possible to reduce the roof opening us-
ing a self-made frame. The roof hatch opening for the installation of the
device should not be larger than 450 mm.
I
Note
The manufacturer only assumes liability for parts included in the scope of
delivery. The validity of the warranty expires if the device is installed to-
gether with third-party parts.
a
Caution – risk of damage
Please observe the structural engineering of the vehicle and seal of all
openings made when installing the roof air conditioner.
Removing the roof hatch
Remove all screws and fixtures of the existing roof hatch.
Take out the roof hatch.
Remove the sealant around the opening using a scraper or similar tool
(fig. 5, page 3).
Use a sealant to seal the bore holes (fig. 6, page 3).
I
Note
Dispose of all waste material, glue, silicone and seals separately. Ob-
serve the disposal guidelines.
7.2.3 Laying the power cable (fig. 7, page 4)
e
Caution – danger of electrocution
Make sure there is no voltage at electrically operated components before
carrying out work on them!
The roof air conditioner must be connected to an electric circuit which
is able to supply the required current.
_IA_CA2500.book Seite 23 Montag, 16. Juni 2008 2:29 14
Zobrazit stránku 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 119 120

Komentáře k této Příručce

Žádné komentáře