Dometic Eskimo Ice 600 Uživatelský manuál

Eskimo Ice 600Installation/Owners ManualSelf Contained Ice Making SystemRevised: 5-5-06L-2448A

Drawing #4Drawing #5Drawing #6

ICE HOSE TERMINATIONFOR REMOVABLE FISH BOXESDrop inFish BoxDrawing #9

Eskimo Ice 600 - Start up procedure form (check mark each box after completion of each step )  1. Record 9-digit Eskimo Ice Serial Number (on front o

Trouble shooting the E.I. 600 if not producing ice 1. Check to see if power is reaching the ice machine. If raw water pump is running, power is reach

7. Check fresh water supply pressure by removing cover to water reservoir and pushing down float from valve. (Water should be running strongly.) The

11. If the ice machine is to be exposed to temperatures below freezing (32°F), water must be drained from machine or potable anti-freeze must be added

Low pressure control is set at approximately +2 lbs. The low pressure control can be tested by holding up the water float in the water reservoir and d

MaintenanceTurn unit off before performing any maintenance. Monthly1. Check the Strainer in the water filter on the fresh water fill to make sure it’s

2YYYYYEnglishL-2448ATABLE OF CONTENTSCopyright 2005 Dometic Environmental Corporation, All Rights Reserved - Every precaution has been taken in the pr

R anco ETC R equires jum per from ‘24VAC’ terminal on top strip to ‘C’ on bottom strip. Thermistor com es pre-connected, and is capable of being le

REV DATE APRDWGREVISION DESCRIPTIONPROPRIETARY NOTE: THE INFORMATION CONTAINED WITHIN THIS DOCUMENT IS THE PROPERTY OF DOMETIC CORPORATION. ANY ATTE

YYYYYEnglishL-2448ATECHNICAL ASSISTANCEApplications:Dometic Environmental Corporation2000 N. Andrews Ave. Ext.Pompano Beach, FL 33069-1497 USAPhone: 9

L-2448ADometic Environmental Corporation2000 N. Andrews Ave. Ext. • Pompano Beach, FL 33069-1497 USA • Phone: 954-973-2477 • Facsimile: 954-979-4414P.

Installation Instructions for E.I. 600 Read all instructions before starting the installation Locating ice machine Locate flat level platform for E.I.

Ice delivery hose installation detail We are using a thru-hull fitting for delivery of ice into storage box. Drill hole for thru-hull fitting in stora

install the male plug to the pump wire (green wire to green screw, black to brass, and white to silver, 115V). (green to green, black and white to bra

Thermostat installation and wiring of the E.I. 600 Installation of temperature control This ice machine uses a Ranco ETC control. We recommend mountin

Corrosion control Covering all electrical components and wiring connections with a corrosion product will help reduce corrosion problems years into th